|
|
|
|
|
Hardened carbon steel SC,
tinted birch birch, elk horn,
tin and birch bones.
Knife wear: Falcon leather
with hand embossing your own
motif "Sosi"
|
Blade SC, Shafst:
Buffalo horn,
birch vril, birch bark.
Cases: Hand embossed
raw edge leather |
Hardened coal steel SC, toned
clove birch, elk horn, tin, birch
fox and buffalo horn.
Knife wear: Falcon leather
with hand embossing your own
motif "Gösta" |
|
|
|
|
|
Blade:SC. Shafts: Hued
birch vril, birch bark,
tin. elk horn and buffalo horn.
Cases: Hand embossed
raw edge leather with
(bear hunting motive. |
|
|
Hardened carbon steel SC, tinted birch birch, elk horn, tin, birch
foxes.
Knife slider: Falcon leather with hand embossing its own motif "Kotten" |
|
|
Blade:
SC. Shaft: Reindeer,
birch bark and tin.
Cases:
Reindeer, raw leather,
hand embossed
|
|
|
|
Surface treatment: Linear oil method
and wax
Maintenance: Oxides on the blade
are removed with chrome powder.
Wood and horn parts are serviced
with a little boiled linseed oil. Leather
is serviced with leather wax.
|
Some simple rules: The knife is not stainless, which means that after use, the knife should be clean and dried dry before it is put back into the knife case. Let the back of the knife run along the inside. After a time of use, a gray surface on the knife forms an oxide that protects the knife. Black rust and red rust should be avoided, these oxides damage the knife. Use the fine eyebrow to tighten the knife.
Good luck with the knife. |
|